If your water system is supplied by a well, it must have at least one pressure tank.  The tank has two chambers.  The upper section is filled with compressed air, the lower section holds water from the well.  The water chamber usually has a rubber liner that provides a flexible diaphragm between the two chambers (like a balloon).

As water flows into the lower chamber, the diaphragm expands and pushes against the air, which is compressed in the upper chamber.  The air pushes back against the diaphragm.

This maintains system pressure.

When you fill water buckets for your horses, air in the upper chamber pushes water out of the tank and into your system.  Check valves in the discharge line from the pump make sure water doesn’t go back into the well.

When the system pressure drops below a pre-set point (determined by the pressure switch), the pump cuts in and refills the tank.

Pressure tanks are usually installed on the ‘raw’ side of the system, that is, upstream of the treatment equipment.  More on that in a subsequent post.

You probably want a pressure tank that holds at least 20 gallons of water.  The more capacity you have, the fewer on/off cycles for the pump, which extends its life.  You can install pressure tanks in parallel for more storage.  A horse ranch should have at least 40 to 60 gallons of water under pressure.  Install a valve at each tank so it can be taken off-line without shutting the system down.

Vendors such as this one offer a range of pressure tanks and parts.

Tanks must be emptied of water before setting the air pressure in the upper chamber, which should be two psi below the ‘low’ setpoint of the pressure switch.  If your switch turns the pump on at 40 psi water pressure, set the pressure in the upper chamber to 38 psi.

Pressure tanks often have valve stems on top similar to those on the tires of your car.  You can use the same tool to check the air pressure in your tank(s).

If you live on a ranch, you may have a portable compressor for keeping the tires of your tractor properly inflated.  You can use the same machine to service your tank(s).

In some areas, large non-pressurized tanks may also be required to provide water for fire protection.  For example, a 5000 gallon poly tank with roof, or two 2500 gallon poly tanks in parallel.  Water in these tanks might sit there for weeks or months.

Bulk tanks don’t store water under pressure.  You’ll need a booster pump to supply the firewater system.

If these tanks provide water for your potable system, the booster pump would send water over to the treatment equipment and then out to your horses.

In both cases, the tanks would hold untreated (raw) water from your well, taken from a point downstream of the pressure tanks.

Your pump may run for several hours when filling a bulk tank.  Make sure you’re not drawing water out of the well faster than it flows in!

Go to this FB page for the latest on the rescue, now in its final stages.  A home is needed for twenty aged and/or blind stallions.

The story of the ISPMB rescue appears on a related FB page.

Three cheers to Elaine Nash and her team at Fleet of Angels, along with Palomino and Matt Armstrong of Chilly Pepper Miracle Mustang!

The ISPMB sanctuary included horses from White Sands NM, Gila Bend AZ, Virginia Range NV and Sheldon National Wildlife Refuge NV.

Now that you found water on your property, you’ll have to bring it to the surface.

If the water level is 30 feet down or less you can install a pump at grade.  This would also apply to water drafted out of a spring or pond.  Keep in mind that surface water is more susceptible to contamination than ground water.

A surface-mounted pump should be self-priming, which means it can draw water from the source even if the suction line is empty.

If the water level is below 30 feet, the pump will have to go down hole.  It has to do three things:

• Lift water to the surface
• Push it into the pressure tank(s)
• Overcome friction in the discharge piping

Suppose you drilled your well to 480 feet.  You hit water at 420 feet and the static water level is at 360 feet.

You don’t want to install the pump at the bottom of the well.  Leave some room for accumulation of silt and sediment.  At least 20 feet.  That puts the pump at 460 feet.  Although the water level is 100 feet higher, the worst case is when you pull water too fast and drop the level down to the pump.

This brings up the concept of recharge rate.  Water enters the well through perforations in the casing.  You don’t want to draw water out faster than it flows in.  At least not for long.  Running a pump dry will destroy it.

Your driller can perform a test to determine the recharge rate.

The system pressure is controlled by a switch that turns the pump on and off automatically.  Typical pressure range is 40 to 60 pounds per square inch (psi).  On at 40, off at 60.  Greatest pressure is therefore 60 psi.  As you use water, the pressure in the system drops until the pump kicks in and refills the tanks.

The amount to allow for pipe friction depends on the water flow rate, pipe size, and length of discharge line (depth of pump plus distance from well to pressure tanks).  If the line is properly sized, this number will be small.  Start with 5 psi.

Summary of conditions for this example:

• 460 foot lift
• 60 psi to get into tanks
• 5 psi pressure loss due to friction

Pumps curves are based on feet not psi.  To convert, multiply psi by 2.3 to get feet.

Total head = 460 + (60 × 2.3) + (5 × 2.3) = 610 feet

Round to 600 feet to keep things simple.  Here are curves for Goulds series 7GS pumps.

Start on the y-axis at 600 feet and move to the right.  When you hit a curve read down to the x-axis.  A 7GS15 pump will give you about 5 gpm.  A 7GS20 will give you 8.5 gpm.  A flow rate of 5 to 10 gpm should be adequate for you and your horses.  Boarding facilities and farms require something larger.

You probably have water under your property.  Technologies are available to help you find it but you might pay over $10,000 for the work.  Old-timers in the area may know where to drill based on their experience.

Another idea is to look at public records (driller’s reports) for nearby parcels.

Keep in mind that if you drill at the low spot on your property you will be pushing water uphill which means lower pressure the higher you go.  Not really an issue on ground that’s fairly level but if you live among rolling hills, where your corral and arena are 80 feet above the wellhead, you’ll lose about 35 psi by the time water gets to your horses.

No wonder it takes 10 minutes or more to fill a water bucket!

Conversely, if your wash rack is 80 feet lower than the wellhead, water may come out of the sprayer with so much force that it’s dangerous to your horse.

Water pressure typically ranges from 40 to 60 psi at the wellhead.  More about that in the next post.

Your driller will recommend an appropriate  casing.   Sometimes it’s PVC, as shown in the Intro.  The casing below is steel.

Your driller will also decide how far to go.  Usually 50 feet or more beyond the point where water is found.

He will install solid or perforated casing as needed, backfill the space around the casing with sand or gravel, and seal the uppermost portion of the bore with cement.

The bottom of the casing is usually left open, in case the well goes dry and you have to dig deeper.

Subsurface pressure may push water up the casing.  Suppose you hit ‘pay dirt’ at 400 feet but water inside the well is at 340 feet.  This is known as the static water level.

Cost to drill depends on several factors but you can start with $40 to $45 per foot.  If your well is 500 feet deep, you will pay at least $20,000.  This does not include the pump, controls, or anything else.

You can’t have horses on your property without a reliable source of water.

Parcels large enough for horses are usually not connected to the public water system.

So you have to provide your own water.

You must be able to give your horse clean fresh water daily, hot or cold, rain or shine.

A rural water system will likely have these components:

• Well
• Pump
• Pressure  switch
• Tanks
• Filters
• Softener
• Charcoal bed
• UV unit
• Power supply
• Piping
• Shed

Here’s what you might see in warmer climates (small risk of freezing temperatures for more than 8 to 12 hours).  Well, pressure tank & switch, power supply & piping exposed to the elements.

Other measures are required for colder climates, to be considered in subsequent posts.

Avoid 90 degree interior corners where a lower horse can be trapped by a higher horse.

Don’t put food and water where a lower horse can’t yield to a higher horse without getting kicked.

Install gates large enough for vehicle access (usually 12 ft).

The dynamics of a family unit are different from a group of randomly chosen horses.

If you place, say three unrelated horses in a corral (e.g., mare and two geldings), you will likely see more pushing and establishment of pecking order.  (Do not be fooled however, they will form a cohesive group.  Some call this ‘buddy sour.’  Use it to your advantage: Learn how to become his best buddy.)

If you adopt a family unit (mare and one or more foals) you may wonder about hierarchy: These guys will eat together on one pile of hay, no pushing.

Not a fan of their discipline but thought this was cute.

Bad horses are not born, they’re made.  If this is what you have to do to stop a horse from being put down then do it.

It’s not the pasture.

He’s not in a class of his own.

It’s you.

If you were trying to teach your horse to pick up his feet or take a halter, would you put him in a round pen and run the crap out of him?

Who’s high horse in your herd?

Does he have two legs or four?

As little as possible but as much as it takes.

Lecture on ‘horse problems.’  The horse knows if you know.

Two things you can do to help him avoid colic:

• Don’t lock him in a stall
• Give him clean fresh water daily

If it’s more work for you it’s better for him.

These guys are not in a barn, they’re in a corral.  Pasture would be better.

Water buckets can be dumped, rinsed and refilled daily.  Bleached weekly.  Mustangs play in their water on hot summer days.  Sometimes a bucket gets damaged.

Don’t get mad when your horse acts like a horse.  Keep a spare bucket in the barn.

Do you think it’s an accident they’re standing the way they are?  No, they’re keeping an eye on their surroundings, especially the photographer.  Haven’t decided if he’s friend or foe.

Give your horse choices.  If he wants to be in the rain he can be in the rain.  If he wants to be under a roof he can be under a roof.

Note the 2×6 rim board added to the pipe panels to satisfy BLM requirements.

If you adopt a mare from the BLM she might be pregnant (unless she’s been in segregated long-term holding for over a year).